Click2Enter-I Access Control Using Your Radio Transceiver for Public Safety and Authorized Users Click2Enter-I
Competitor's Price $935.00Our Price $880.00

Click2Enter does away with all of the cumbersome keys, access control codes, and remote control actuators, because every emergency response vehicle and responder carries the key-their mobile or portable radio transceiver. Click2Enter was developed to provide public safety personnel or any authorized user immediate access to gated residences; communities; or any security control mechanism. Other authorized users can even use the Click2Enter, as long as they are programmed into its frequency bank and have a radio transceiver. Click2Enter, compared to other emergency access systems, will set the industry standard for many years to come.

Click2Enter-I takes advantage of state of the art electronics presently being designed into scanner radio technology. This modified scanner/radio technology provides public safety agencies with a quick, safe, reliable, and stealthy means to activate gates, bollards, doors, or any security control mechanisms.

Public safety agencies, such as Fire Departments, Police/Sheriff Departments, and Ambulance/Rescue Companies are issued radio frequencies by the FCC for their restricted use only. Possession of transmitting devices for non-authorized personnel is tightly controlled and transmitting on these frequencies is against the law (Federal & State statutes). The public's right to receive these emergency agency communications is not restricted, thus it is legal to possess emergency response scanning devices.

The Click2Enter-I combines the scanner/receiver technology with control technology to act as a radio controlled key to open access control devices (gates or security control mechanisms), thus allowing public safety agencies or any authorized users immediate access to deal with emergencies as they occur. To activate the Click2Enter-I the operator must be proximate to the device, and using short transmission pulses of their radio transceiver (software enabled one or two pulse mode) is all that is required to initiate an instant activation/entry.

The Click2Enter-I uses technology that is inherent in most all radio broadcast equipment and adapts this technology to work as a control mechanism. We increase the security of the Click2Enter-I by requiring a verification of the FCC assigned carrier frequency and the agency assigned sub-audible communication (private line code). So it takes two separate verifications to effect an activation of the device.

Click2Enter-I stores a running activation log, in memory, for operator recall. The Click2Enter system allows any public safety agency or authorized users access, as long as they are programmed into it's memory. Having the ability to program in multiple users answers the mutual aid problem that presently exists with other emergency access control products.

Programming of the Click2Enter-I is accomplished by way of an RS-232 computer interface, so any computer or similar device using standard modem protocol software can be used. Several more unique and desirable features are designed into each Click2Enter-I; please refer to the features list above for more details. The entire activation sequence takes less than four seconds. The operator can be either on foot (using a portable radio), or in a moving vehicle (using portable or mobile radio)-It's as easy as:

1. Click
2. Red LED goes on
3. Release after light turns off
   (Using Single Pulse Mode After First Pulse Skip Steps 4, 5, & 6)
4. Red LED goes on a second time
5. Click
6. Release after light turns off
7. Red LED blinks, Gate Opens

Innovative, cutting edge, reliable, flexible, safe, quick, easy to use are just some of the many ways to describe the Click2Enter-I. The Click2Enter-I will revolutionize the emergency access industry and set the standard for many years to come. The Click2Enter-I has been on the market for well over four years with many satisfied customers. None of the other products, presently being marketed in this field, compare to the Click2Enter.