The MGO20 is
designed for use on doors and gates up to 1-1/2 inches
thick. To install, simply attach the rigid PVC or
aluminum mounting channel and slide sensor into the
channel. This edge cannot be bent or folded. |
 |
The MGR20 is
designed for use on 2 inch round gates. To install,
simply attach with screws through mounting tabs and
into gate. This edge cannot be bent or folded.
|
 |
Call for Dealer/ Retail Pricing 775-588-1475
 |
Call for Dealer/ Retail Pricing 775-588-1475
|
The MGS20 is designed for use on 2 inch square gates. To install, simply
attach with screws through mounting tabs and into gate. This edge cannot
be bent or folded.
|
 |
The Miller Edge Model MWT02 gate and door edge
transmitter is designed to provide obstacle sensing
protection for a variety of motorized gates and doors. |
 |
Call for Dealer/ Retail Pricing 775-588-1475
|
Call for Dealer/ Retail Pricing 775-588-1475
|
The Miller Edge Model MWTA02 gate and door edge
transmitter is designed to provide obstacle sensing
protection for a variety of motorized gates and doors.
The Model MWTA02 is available with an Audible Alarm
feature that activates when the battery has only 25%
of its life remaining, indicating the battery should
be replaced. |
 |
Both the Miller Edge receiver and transmitter are
designed to have several selectable options not found
on other radio controls. Simply select these options
with the convenient dip switches and wire harness. The
receiver will operate on either 12 or 24 volt AC or DC
and is capable of sending a pulse or continuous
signal. |
 |
Call for Dealer/ Retail Pricing 775-588-1475
|
Call for Dealer/ Retail Pricing 775-588-1475
|
Both the Miller Edge receiver and transmitters are
designed to have several selectable options not found
on other radio controls. Simply select these options
with the convenient dip switches and wire harness. The
receiver will operate on either 12 or 24 volt AC or DC
and is capable of sending a pulse or continuous
signal. |
 |
The Miller Edge Model MWCK02
gate and door edge transmitter and receiver kit, is
designed to provide a fully reliable, self checking
communication between the 4-wire SensingEdge and the
door or gate motor operator. When the SensingEdge
detects an obstruction, a fault condition is
communicated to the transmitter and the receiver. The
signal is then passed on to the motor operator to
control the motion of the door or gate. |
 |
Call for Dealer/ Retail Pricing 775-588-1475
|
Call for Dealer/ Retail Pricing 775-588-1475 |
