The ME120 is
designed for use on doors and gates up to 1-1/2 inches
thick. To install, simply attach the rigid PVC or
aluminum mounting channel and slide sensor into the
channel.
 |
 |
The ME123 is
designed for use on 1-1/2 to 2 inch thick doors and
gates. To install, slide the edge into the mounting
channel and then mount the assembly to the door.
|
 |
Call for Dealer/ Retail Pricing
775-588-1475 |
Call for Dealer/ Retail Pricing
775-588-1475 |
The MGO20 is designed for use on doors and gates up to 1-1/2 inches thick.
To install, simply attach the rigid PVC or aluminum mounting channel and
slide sensor into the channel. This edge cannot be bent or folded. |
 |
The MGR20 is designed for use on 2 inch round gates. To install, simply
attach with screws through mounting tabs and into gate. This edge cannot
be bent or folded.
|
 |
Call for Dealer/ Retail Pricing
775-588-1475 |
Call for Dealer/ Retail Pricing
775-588-1475 |
The MGS20 is
designed for use on 2 inch square gates. To install,
simply attach with screws through mounting tabs and
into gate. This edge cannot be bent or folded.
|
 |
The Miller Edge Model MWT02 gate and door edge
transmitter is designed to provide obstacle sensing
protection for a variety of motorized gates and doors. |
 |
Call for Dealer/ Retail Pricing
775-588-1475 |
Call for Dealer/ Retail Pricing
775-588-1475 |
The Miller Edge Model MWTA02 gate and door edge transmitter is designed to
provide obstacle sensing protection for a variety of motorized gates and
doors. The Model MWTA02 is available with an Audible Alarm feature that
activates when the battery has only 25% of its life remaining, indicating
the battery should be replaced. |
 |
Both the Miller Edge receiver and transmitters are designed to have
several selectable options not found on other radio controls. Simply
select these options with the convenient dip switches and wire harness.
The receiver will operate on either 12 or 24 volt AC or DC and is capable
of sending a pulse or continuous signal. |
 |
Call for Dealer/ Retail Pricing
775-588-1475 |
Call for Dealer/ Retail Pricing
775-588-1475 |
Both the Miller Edge receiver and transmitters are
designed to have several selectable options not found
on other radio controls. Simply select these options
with the convenient dip switches and wire harness. The
receiver will operate on either 12 or 24 volt AC or DC
and is capable of sending a pulse or continuous
signal. |
 |
The Miller Edge Model MWCK02 gate and door edge transmitter and receiver
kit, is designed to provide a fully reliable, self checking communication
between the 4-wire SensingEdge and the door or gate motor operator. When
the SensingEdge detects an obstruction, a fault condition is communicated
to the transmitter and the receiver. The signal is then passed on to the
motor operator to control the motion of the door or gate |
 |
Call for Dealer/ Retail Pricing
775-588-1475 |
Call for Dealer/ Retail Pricing
775-588-1475 |
