swing gate operator
    swing gate opener      
Contractors Lic.  NV. #57900   CA #363787
Phone Hours (PST)
   since 1978
7:30 to 4:00 Mon.-Fri.
 Phone 775-588-1475 or Go to Our Main Store
gate opener Stop!! Click Here to see all our products at Main Store
Home 
electric gate openers
Swing Gate Openers
Slide Gate Operators
Barrier Gate Openers
gate operator
Upswung Manual
Barrier Gates
 
Elite
Residential Electric

Gate Openers
Commercial Electric
Gate Openers
automatic gates
Swing Gate Operators

Slide Gate Operators
Barrier Gate Operators
stanleysentex
Automatic Gate Opener Replacement Parts for HL410-11 to 440
FAAC
FAAC Swing

Gate Operators
FAAC Slide
Gate Operators
Doorking
DoorKing Access DKS
Doorking Gate Openers
Milleredge Safety
MillerEdge
electric gate openers
GiBiDi  HL series   Modo Gate Openers
EMX
Probe  Sensors 
Loop detectors

LINEAR ACCESS CONTROL AP-4 SINGLE DOOR GATE CONTROLLER WITH RADIO RECEIVER 
ACCESS CONTROLThe AP-4 is a single door gate controller with a built-in radio receiver that supports up to 339 transmitters that have a single entrance or gate, the AP-4 is the ideal wireless-based access control system. It can be used to remotely activate devices such as gate operators, door strikes, or door operators. Based on the proven AP-1, AP-2 and AP-3 access controllers, the AP-4 is small enough to be mounted within the gate operator. The AP-4 has a built-in radio receiver. It has a 250 foot range that can be extended even farther with an optional EXA-2000 antenna. Two relay outputs are provided: one for gate or door access; the other for obstacle control using the MGT, the industry’s only supervised safety edge transmitter. The AP-4 looks for an hourly status transmission from the MGT to report on transmitter functionality, battery condition, and case integrity. If any of those conditions require attention, the AP-4 will alert the user by beeping once every five seconds. The user must then activate the transmitter twice in order for the AP-4 to grant access. Installation and set-up are simple. The AP-4 operates on 12-24 volts, ac or dc. It can be powered directly from the radio power output of most gate operators. Learning, suspending, or deleting transmitters is as simple as pressing few keys on the AP-4’s built-in keypad. Program data is stored in non-volatile EEPROM; data retention is in excess of ten years, even in the event of a power failure. The AP-4 is compatible with all MegaCode format transmitters, which come factory programmed with one of over 1,000,000 possible codes, all but eliminating any chance of duplication

Features:

  • Ideal for gated communities, parking facilities, and industrial sites.
  • Easy to set-up and use — up to 480 remotes can be programmed with a few keystrokes.
  • Easy to add, suspend, and delete transmitters through programming mode — no transmitter dip switches to set.
  • Supports 480 block coded transmitters or 238 individual transmitters/wireless keypad entry codes.
  • Supports one fully supervised reversing edge transmitter.
Linear Access List Price  Internet Price
AP-4  ACP00894 $154.00 $95.00
 
Gate operator installations should be completed by a qualified installer only. Electric Gate Openers  assumes no liability if product is installed incorrectly. Please see owners / installation instructions for complete details.
For Sales Information
mail@swing-gate-products.com


swing gate opener

  Copyright © 2009